Your cart
There are no more items in your cart
The Darimo Epsilon MTB integrated handlebar is designed for Cross Country and Marathon bikes, maintaining the characteristic lightness of our products with only 148 g for a 60mm stem.
The handlebar is entirely made of carbon fiber, with an exclusive combination of bidirectional and unidirectional fabrics.
The correct arrangement of the fiber layers has been achieved after finite element calculations and destructive tests. Thanks to our iterative test-improvement process, an improvement has been achieved in terms of the stiffness and safety of the product without affecting the final weight of the product.
Like all our products, this degree of laminate architecture is only possible through completely handcrafted manufacturing, where each layer is placed by hand and adjusted precisely for each handlebar. The number and orientation of the layers varies in each area to optimize stiffness, absorption and resistance.
General Specifications
- Handlebar width: 740 mm
- Backsweep: 6° / 9°
- Steerer tube diameter: 1 1/8"
- Clamping area height: 33 mm
- Available angles: -12°, -17°, -25°
- Stem lengths: 50, 60, 70, 80 mm
- Material: UD and bidirectional carbon fiber fabrics
- Available finishes: UD, 3K or Forged, matte or gloss
- Reference weight: 148 g (60 mm) – 160 g (80 mm)
- Recommended rider weight limit: 90 kg
Available Combinations Table
| 50 | 60 | 70 | 80 | 90 | 100 | |
|---|---|---|---|---|---|---|
| -6° | ||||||
| -12° | ✔ | ✔ | ||||
| -17° | ✔ | ✔ | ✔ | |||
| -25° | ✔ |
Materials
- Unidirectional and bidirectional carbon fiber
- Titanium hardware
- Internal aluminum cylindrical nuts
Weight
Weight varies according to stem length and angle. Reference values:
- 148 g with 60 mm stem
- 160 g with 80 mm stem
Important Notice
- WEIGHT LIMITATION 90KG If you need your handlebar to be reinforced, select it in the handlebar specifications before purchasing it. Please note that this modification involves an increase in weight.
- DO NOT CUT THE HANDLEBAR The ends have internal reinforcements; cutting it compromises its integrity.
- ROUTING COMPATIBILITY Our handlebars are prepared by default for complete cable integration in the most common systems. The cable routing holes near the brake levers have a diameter of 10mm to facilitate cable passage. Cable exit can go in front of the steerer tube or through the inside of it. In both cases, holes are made to allow passage without difficulties. There is the possibility of routing cables outside the frame by making holes in the central area of the handlebar.
- CYCLING COMPUTER MOUNTS The Epsilon is prepared for computer mounts with two bolts that allow adjusting the distance of the computer from the handlebar. We have adapter plates for Garmin and Wahoo. All brands compatible with the previous ones can be used with our adapters.
- STEERER TUBE ADAPTERS
- For steerer tubes with "D" shaped cross-section (not round), you will need to specify the model in the comments field to supply the internal piece that completes the steerer tube, thus ensuring correct tightening of the stem bolts. In this configuration, a hole will be made in the internal face of the stem facing the steerer tube.
- For frames with cable integration, our design department has created adapters for most current models. It is necessary that if you choose our handlebar you must choose the correct adapter plate model to be able to mount the handlebar.
- DI2
The following image describes all the predefined options where Di2 holes can be made. If you need positions different from the predefined ones, it is necessary to indicate it in the order comments.
Custom
It is possible to request custom manufacturing: special reinforcement, layer adjustment, aesthetic modification or specific configuration upon request. Each unit is produced handcrafted, allowing exclusive adaptations.
